Rectorseal cg90 Flat 90 Degree Elbow Line Set Cover

Product DescriptionThe RECTORSEAL cg90 is a flat 90-degree elbow fitting designed for use with the Cover Guard line set cover system. It connects to compatible duct sections and redirects the line set run at a 90-degree angle in a flat plane, keeping refrigerant lines, electrical conduit, and condensate tubing concealed and protected. At 4.5 inches, it fits multi-zone line set cover applications. The fitting ships with a stay-clean peel-and-go protective film and features pre-installed sliding zip-tie clips for a clean, organized installation. HVAC technicians installing mini-split or central system line set covers will find this elbow a direct-fit component within the Cover Guard system.The cg90 is suited for both single-zone and multi-zone line set cover installations in residential and light commercial settings. It is used wherever a line set run must change direction horizontally at a 90-degree angle along a wall or building exterior. The fitting accepts paintable finishes in white, brown, and gray, making it adaptable to a range of exterior and interior color schemes. It is appropriate for mini-split installations, heat pump line sets, and similar applications where a finished, professional appearance is required.Key FeaturesFlat 90-degree elbow design for horizontal direction changes in Cover Guard line set cover systemsMulti-stage adjustability for flexible fitting alignment during installationQuick-snap cover that stays locked and will not pop off under normal service conditionsPre-installed sliding zip-tie clips for organized line managementNo-rust, quarter-turn cam screws for corrosion-resistant fasteningUV-resistant construction suitable for exterior exposurePaintable white finish with compatible brown and gray color options availableCompatibilityDesigned for use with the RECTORSEAL Cover Guard line set cover system in single-zone and multi-zone configurations at the 4.5-inch duct width.Installation NotesInstallation is typically performed by a licensed HVAC technician as part of a complete line set cover system. Disconnect and isolate the refrigerant system and power to all associated equipment before routing or re-routing line sets. Align the cg90 elbow with adjoining Cover Guard duct sections before engaging the cam screws to ensure proper fit. Remove the peel-and-go protective film from all surfaces after installation is complete.Technical SpecificationsFitting Type: Flat 90-degree elbowDuct Width: 4.5 inchesApplication: Single and multi-zone line set cover systemsUV Resistant: YesPaintable: YesColor: White (compatible with brown and gray options)Fastener Type: Quarter-turn cam screws, no-rustStandard InformationBrand: RECTORSEALManufacturer Part Number: cg90